Point-to-point bridge versus wireless extender

Rebuild the comparison infographic with strict geometric clarity. LEFT HALF ONLY: show exactly two separate buildings, one on the far left and one on the far right. Put exactly one identical directional bridge antenna on each building, mounted on the roofs and visibly facing each other. Draw exactly one straight, narrow, horizontal beam connecting the two antenna faces. The beam must begin at the face of the left antenna and end at the face of the right antenna. It must not pass above, below, or beside either antenna. Do not show any second receiver, duplicate antenna, extra beam, radiating lines, glow rays, arrows, or other signal paths on the left. RIGHT HALF ONLY: show one single building with exactly one wireless extender/router inside it and soft circular coverage waves contained entirely within that building; no second device and no directional beam. Use clear labels 'Point-to-point bridge' and 'Wireless extender'. Make the infographic simple, diagrammatic, technically accurate, and easy to read; muted green and cool neutral palette, wide landscape layout. Prioritize one bridge antenna per building and one beam touching both antenna faces over decorative detail.

Comments

Leave a Reply